![]() The Display and AppendToGraph dialogs now avoid generating commands with more than 100 waves, which had provoked a "too many waves" error message. SetIgorHook's hook functions are no longer forgotten when re-opening an experiment that set them, fixing a bug introduced in Igor 6.35.Ī relative include statement like #include ":folder:file" works even within a procedure file that has been included into an independent module.įixed possible crash if you did a polynomial fit in a preemptive thread. Bug FixesĬhanged code for complex division to correct cases where the divisor contains INF.Ĭorrected labels in StatsAnova2Test when the input data used dimension labels for the rows and the columns. The areaXY and BinarySearch functions now tolerate leading and trailing NaNs in the input waves. See ModifyAxis zero and gridEnab keywords. ModifyGraph zero(left)=1,gridEnab(left)= // command uses fractions, dialog % After that you can turn the grid off, leaving only the zero line: To set a fractional zero line using the Modify Axis dialog (in the Ticks and Grids tab) you need to enable the relevant grid. The axis zero line now honors the gridEnab setting (for drawing between a % to b % of the plot area.) The Igor application's file version is 6.3.7.2. ![]() Here are the updates in reverse chronological order: This includes all changes made after Igor Pro 6.22A was released. This file describes significant changes made to Igor Pro and supporting files since the initial public beta of Igor Pro 6.3. Wide-Angle Neutron Spin Echo Spectroscopy.Simply create a window named "Graph0" then run "Demo1()" to replicate what I'm seeing. Sure, you can't click back on the control panel if you currently have the graph selected, but if you click OUT of igor, then click directly on the control panel, it allows you to do that. (many) variables between functions, and that'd take ages and make everything ugly.Ĭrap. but at this point that'd involve passing many. Sure, I could probably do it in multiple functions. Basically I just need my program to wait for me to adjust that spline fit, then continue on it's merry way. Then you adjust the points to get a good match with your background, then you can choose to subtract it if you'd like. So you run the initialization for the program, which creates the spline fit wave, then puts it on your graph. Basically I'm using the spline fit background removal "package" discussed elsewhere on the site, which allows you to adjust the "points" where the spline fit runs through. How is this accomplished? What I'm trying to do is to have the program wait for me to adjust a spline fit to remove the background on the first of many sets of data imported into igor. Therefore I cannot click the continue button and end the program. I can click continue and close the graph window, but then I obviously can't do anything else (as I haven't added another button to "kill" the control panel.) However, if I click the graph after I start the program, it will not let me interact with the control panel again. Initially, it'll let me interact with the control panel window. If I change the pauseforuser to act on the graph window instead, here's what happens. However, by default I cannot interact with any other window while the control panel is up. By default, the "continue button" simply closes the "control panel" window, which then ends the PauseforUser. I'm attempting to allow a procedure to let me interact with a window while it waits, but if I play around with the demo program, discussed in the "PauseforUser control panel example" in the manual.
0 Comments
Leave a Reply. |